1: Detail showing location of removable plastic pcs #4 and push down plastic piece No.5įig 3: Detail showing where the location of pre-feed sensor lever Paper will often tear away and be stuck in this area, look for small pieces of paper.įig. The flag for pre-feed sensor is off center to the left (See Fig. Open the top lid / cover, remove print cartridge, pull out the plastic block (with #4 on it), press down on the part with the No.5 on it, this opens up the paper path so you can see the path that paper takes when comingįrom the lower trays (See Fig's 1 and 2). Sometimes paper will jam and part of the page may rip off and be left within the printer.įind the pre-feed sensor and look for a document jam. If you do get main motor spinning, then focus needs to be on the top of page and pre-feed sensors.Įxamine the paper path for a stuck piece of paper or impediment. NOTE: At initial power on, if the printer fails to spin the printer motors then focus your attention on the fuser area of printer. This can also be a incorrect jam, in some cases no paper is found in the paper path but the error condition is caused by a stuck sensor lever or in some cases a faulty sensor. NOTE: A sensor lever is a flag that moves as the paper passes and blocks or unblocks the actual optical sensor. The error may also occur if one of the sensor lever is stuck in a down position. This error can appears if paper is stuck in the path holding down the paper path sensors. Instructions for Troubleshoot 13.20 Paper Jam Errors - HP LaserJet 4200, 4300, 4240, 4250, 4350, P4010, P4014, P40 Series PrintersĪ 13.20 error can occur on power up when the printer believes paper is stuck in the paper path.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |